Ask questions about projects relating to: aerodynamics or hydrodynamics, astronomy, chemistry, electricity, electronics, physics, or engineering
Moderators: MelissaB, kgudger, Ray Trent, Moderators
My 9 year old is doing the project Spin Right Round. He is just starting but has a few questions. First, he wants to know if the red and blue wires that came attached to the battery holders need to be attached to anything like the axel support? If not, what does he do with them? Also, he would like to know if he could place the battery holder on its side, with the battery in it, and then glue the magnet to the top plastic side of the battery holder instead of having the magnet lay on top of the battery. Finally, he wants to know if he can hot glue plastic beads to the knot or next to the knot he makes on the coiled loops of wire. He saw this in another help video while he was doing his research. Thanks so much for your help!
- Posts: 1
- Joined: Sat Apr 07, 2012 2:33 pm
- Occupation: PARNET - STAY AT HOME MOM
- Project Question: SPIN RIGHT ROUND PROJECT: With this experiement what do you do with the back and red wires that are on the battery holder? Should they be connected to something like the axel support? Also, does the magnet lay right on top of the battery or can we lay the battery holder with the battery inside of it on its side and glue the battery to the side of the battery holder?
- Project Due Date: Last week of April
- Project Status: I am just starting
Hello and welcome to the forums!
The battery terminals need to be attached to the axle supports. Remember that it's important that the coil wire ends be stripped of insulation on one side only. The circuit is from one battery terminal, through the axle support, 1/2 the time through the coil and back through the other axle support to the other battery terminal.
I would think you can put the magnet anywhere you want, as long as it's beneath the coil (and the coil is close to it, but not touching it.)
It sounds like the beads in the video are performing the same function as the knot in this experiment, just keeping the wires together. Be careful with hot glue on the coil wires. You don't want the heat to melt the wire insulation. I would stick with the knot only.
- Posts: 421
- Joined: Wed Sep 17, 2008 9:20 pm
- Occupation: electronic engineer
- Project Question: n/a
- Project Due Date: n/a
- Project Status: Not applicable
Return to Grades K-5: Physical Science
Who is online
Users browsing this forum: No registered users and 3 guests