Fan dimension

Moderators: MelissaB, kgudger, Ray Trent, Moderators

Fan dimension

Postby jvenetta » Thu Dec 05, 2013 1:20 pm

I am building the sub sonic wind tunnel. I am not able to find a fan (plastic mount w/side air draw) with a mounting assembly that will fit on the 17" sq drive assembly board. If I increase the size of the drive assembly board to 19" sq, are there any negative impacts or adjustments I should make to minimize any of those impacts.

Thanks!
jvenetta
 
Posts: 1
Joined: Wed Dec 04, 2013 11:05 pm
Occupation: Software Engineering Director
Project Question: My question is in regard to building a sub-sonic wind tunnel
Project Due Date: n/a
Project Status: Not applicable

Return to Grades 9-12: Wind Tunnel

Who is online

Users browsing this forum: No registered users and 2 guests