Related Links

  • Science Fair Project Guide

Project Summary

Difficulty  7 
Time required Average (about one week)
Prerequisites To do this project, you will need access to a laboratory with facilities for culturing bacteria. You should be familiar with sterile technique and proper handling of bacterial cultures.
Material Availability Specialty items
Cost Average ($50 - $100)
Safety Adult supervision required. Read and follow the safety note below on ultraviolet light. Follow standard precautions for handling bacterial cultures.

Donate to Science Buddies

Sponsor

Sponsored by a generous grant from The Abbott Fund

Internet Safety Tips
Get educated about online safety
with help from Symantec.

symantec.com/norton/familyresources

Abstract

Ultraviolet light can damage DNA molecules. If a cell's DNA repair mechanisms can't keep up with the damage, mutations are the result. As harmful mutations accumulate, the cell eventually dies. How much ultraviolet light is too much for a bacterial cell?

Objective

The purpose of this project is to observe the effects of short-term ultraviolet light exposure on bacteria.

Introduction

Ultraviolet (UV) light is invisible to our eyes, and has higher energy than visible light. "When considering the effect of UV radiation on human health and the environment, the range of UV wavelengths is often subdivided into UVA (400–315 nm), also called Long Wave or 'blacklight'; UVB (315–280 nm), also called Medium Wave; and UVC (< 280 nm), also called Short Wave or 'germicidal'." (Wikipedia, 2006a) Short-wavelength UV light has enough energy to damage chemical bonds in DNA molecules, which are very stable under most conditions.

"Ultraviolet light is absorbed by a double bond in pyrimidine bases (such as thymine and cytosine in DNA), opening the bond and allowing it to react with neighboring molecules. If it is next to a second pyrimidine base, the UV-modified base forms direct covalent bonds with it. The most common reaction forms two new bonds between the neighboring bases, forming a tight four-membered ring (see Figure 1, below). Other times, a single bond forms between two carbon atoms on the rings, forming a '6-4 photoproduct.' These reactions are quite common: each cell in the skin might experience 50-100 reactions during every second of sunlight exposure." (Goodsell, 2001)

effects of UV light on DNA
Figure 1. Short wavelength UV light can cause adjacent pyrimidine bases in DNA (thymine and cytosine), to bond to one another instead of the complementary DNA strand. This disrupts DNA replication.

Cells have mechanisms to repair this damage, but if the duration of exposure to UV light is sufficient, the repair mechanisms are unable to keep up with the rate of DNA modification. Short wavelength UV light can thus serve as a germicide.

germicidal ultraviolet light
Figure 2. Short wavelength UV lights are often used to prevent microbial growth on work surfaces in tissue culture hoods, like this one.

In this project, you will determine how much UV light exposure is needed to kill bacteria in culture plates.

Terms, Concepts and Questions to Start Background Research

To do this project, you should do research that enables you to understand the following terms and concepts:

Questions

Bibliography

Materials and Equipment

To do this experiment you will need the following materials and equipment:

Experimental Procedure

Safety Note: adult supervision is required for this project. Read and follow these Ultraviolet Light Safety Precautions (IBC UMN, 2003):

  • The germicidal ultraviolet (UV) light used in this project will also damage unprotected human cells. Your eyes and skin are particularly susceptible to UV damage.
  • Exposure to UV light can burn the retina or irritate the cornea and the conjunctiva. This can cause a feeling of "sand in the eye" and heightened sensitivity to light. Symptoms appear from 6 to 24 hours after exposure and usually disappear within 48 hours.
  • Persons who have had the lens of an eye removed (e.g. cataract surgery) can receive permanent retinal damage from UV exposure - including blindness.
  • Individuals who are exposed to photosensitizing agents (e.g. some oral drugs or topically applied creams) may not be aware of heightened sensitivity to UV radiation.
  • UV radiation burns skin promoting skin aging and cancer.
  • If possible, the UV source for irradiating bacterial cultures should be operated remotely, so that the Investigator is not exposed to UV light.
  • If this is not possible, then the UV source should be set up so as to avoid direct exposure to the Investigator (i.e., placed behind a UV-blocking barrier).
  • The Investigator should also use the following personal protective equipment:
    • All skin should be protected including face, neck, hands, and arms.
    • Wear gloves and long sleeves covering all skin above the gloves.
    • Eyes and face should be protected by a face shield designed to block the UV wavelengths used. Radiation can readily reach the eyes through the open sides of standard eye glasses, so they do not provide sufficient protection.

  1. Prepare 15 plates of chosen bacteria: pipette 100 μL from the liquid bacterial suspension, and spread it on the plate. Cover the plate and wait 5 minutes for it to dry.
  2. Protect half of each plate from UV light by using aluminum foil to cover half of the lid for each plate.
  3. You will use the plates in five groups of three plates each. All plates should be at the same distance from the UV source. The following table shows the suggested UV exposure time for each group of plates. Remember to read and follow the UV light safety precautions (above) while performing this step.
    Group UV light exposure time (seconds)
    1 15
    2 30
    3 60
    4 120
    5 300
  4. Immediately after the UV light exposure, use a permanent marker to indicate which half of each plate received UV light, and the duration of the exposure.
  5. Remove the foil coverings, then incubate the plates, inverted, overnight at 37°C (or longer if at lower temperature).
  6. Count colonies in both halves of each plate.
  7. For each group of plates, calculate the average and standard deviation of the number of colonies in each half of the plate.
  8. Make a graph showing the average number of colonies (y-axis) as a function of UV exposure time (x-axis).
  9. On the same graph, you can also use a different symbol to plot the average number of colonies on the unexposed (control) side of each plate.
  10. Is the average number of control colonies consistent across the five groups of plates? Why or why not?
  11. What duration of UV exposure results in 50% bacterial mortality? Are there any plates with 100% bacterial mortality? If so, what duration of UV exposure results in 100% bacterial mortality?

Safe Disposal of Plates

At the conclusion of the experiment, all plates should be disinfected for safe disposal.

  1. The best way to dispose of bacterial cultures is to pressure-sterilize (autoclave) them in a heat-stable biohazard bag.
  2. If autoclaves or pressure cookers are not available, an alternative is to bleach the plates.
    1. Wear proper safety equipment (gloves, lab coat, eye protection) when working with the bleach solution; it is corrosive.
    2. Saturate the plates with a 20% household bleach solution (in other words, one part bleach and four parts water).
    3. Allow the plates to soak overnight in the bleach solution before disposing of them.
    4. Please note that the bleach solution is corrosive and needs to be thoroughly rinsed afterwards.

Variations

Be sure to follow the UV light safety precautions (above) for all of these experiments.

Credits

Andrew Olson, Ph.D., Science Buddies

Sources

This project is based on:


Last edit date: 2007-03-22 22:00:00

Career Focus

If you like this project, you might enjoy exploring careers in Microbiology.

Microbiologist
Microorganisms (bacteria, viruses, algae, and fungi) are the most common life-forms on Earth. They help us digest nutrients; make foods like yogurt, bread, and olives; and create antibiotics. Some microbes also cause diseases. Microbiologists study the growth, structure, development, and general characteristics of microorganisms to promote health, industry, and a basic understanding of cellular functions. 		 


Join Science Buddies

Become a Science Buddies member! It's free! As a member you will be the first to receive our new and innovative project ideas, news about upcoming science competitions, science fair tips, and information on other science related initiatives.

Support Science Buddies

If this website has helped you, won't you consider a small gift so we may continue developing resources to help teachers and students?

 


 

Science Buddies gratefully acknowledges its Presenting Sponsor
 
It's free! As a member you will be the first to receive our new and innovative project ideas, news about upcoming science competitions, science fair tips, and information on other science related initiatives.


Science Fair Project Home      Our Sponsors      Partners      About Us      Volunteer      Donate      Contact Us      Research Grants & Outreach      Site Map

Science Fair Project Ideas      Science Fair Project Guide      Ask an Expert      Blog      Teacher Resources      Parent Resources      Student Resources      Science Careers      Join Science Buddies     

Privacy Policy Science Buddies

Copyright © 2002-2010 Kenneth Lafferty Hess Family Charitable Foundation. All rights reserved.
Reproduction of material from this website without written permission is strictly prohibited.
Use of this site constitutes acceptance of our Terms and Conditions of Fair Use.