Using just a single sheet of paper (8.5 x 11 inches) and up to five paper clips, can you build a bridge that will span 20 cm and support the weight of 100 pennies? The area beneath the span must be free (so that boats can pass beneath it). To test your bridge, place two books 20 cm apart, and set the bridge on the books, spanning the gap. Do not fasten the bridge to the book (nor to any other support). Does your bridge hold as much weight as you expected it would? If your bridge fails…
Suspension bridges, with their tall towers, long spans, and gracefully curving cables, are beautiful examples of the work of civil engineers. How do the cables and towers carry the load that is on the bridge? Can a suspension bridge carry a greater load than a simple beam bridge? This science project shows you how to find out.
Try different wind turbine/propeller (chord length, pitch) designs by making models from balsa wood. Connect the spinning axle to a DC motor and measure the voltage produced across a resistor to measure power output. Use fan as wind source. (Judge, 2004)
Predict how tall you can build a tower using only two sheets of newspaper as building material. You can't use tape, glue, staples, or anything else, just two sheets of newspaper. You can tear, bend, cut, or fold the newspaper. Try it out and see how close you can come to your prediction. Can you beat your prediction? As you're building, you may come up with ideas to make a better tower. Try them out! (It's not like the materials are expensive!) Here are some variations you might want to…
Start with 7 drinking straws and 14 paper clips. Use the paper clips to fasten the straws together. Here's how: 1) Clip two paper clips together, narrow end to narrow end. 2) Push the wide ends of each clip into the end of a straw. That's it! Connect four straws to make a square, and three straws to make a triangle. Now test which shape is stronger. Hold the shapes vertically, with an edge or a vertex resting on the tabletop. Have a helper push on the opposite side or vertex. Which shape…
Have you ever flown in an airplane, or looked up at one flying in the sky, and wondered how such a massive machine can stay in the air? Airplanes can stay in the air because their wings, also referred to as airfoils, generate lift. Engineers use devices called wind tunnels to experiment and test different wing shapes when they design new airplanes. Wind tunnels let engineers make careful measurements of the air flow around the wing, and measure the amount of lift it generates.
If you can get…
A bridge collapse, like that of the I-35W Mississippi River Bridge shown below, can be a major disaster. Bridges that cannot hold enough weight to do their intended job can be a serious public safety issue. And if they collapse, they can also cause economic damage due to costly rebuilding and people and companies scrambling to figure out how to circumvent the months of traffic impacts.
#* IMG 1 *#
On August 1, 2007 the I-35W Mississippi River Bridge collapsed killing 13…
+ More Details
- Less Details
Average (6-10 days)
A kit for this project is available from [# Link Name="CE_p011.6" Value="HtmlAnchor" HtmlText="AquaPhoenix Education" #].
What are the best materials to use for blocking out unwanted noise from the environment? You can build a test box (or test frame) around an audio speaker. Use a sound level meter to measure the speaker output. Use different materials to cover the walls of your test box (or frame), and see which materials do the best job at blocking the sound. For a more advanced project, perform your tests using different sound frequencies. Are some materials better at blocking certain frequencies than…
Here's a fun project idea to learn about compression forces. For this experiment you'll need some empty toilet paper tubes, masking tape, sand (or table salt), pebbles (or marbles), a funnel, a cardboard box, and a sturdy chair to help you balance while testing the column. Seal one end of the tube with masking tape. Use the funnel to fill the tube with sand (or salt). Seal the other end with tape. Place the tube on end inside the paper box. Place the chair with its back to the box and hold…
There are many types of construction materials used for wood-frame houses. Compare the different uses for and strengths of different building materials, e.g.: particle board,
plywood, pine, oriented strand board (OSB), and drywall (gypsum board, SheetRock). The Science Buddies Materials Science Resource will be helpful for learning about different ways to measure material strength. You should be sure to use the same cross-sectional area of each material in order to make fair comparisons.…
You can find this page online at: http://www.sciencebuddies.org/science-fair-projects/search.shtml?v=solt&pi=Aero_p030
You may print and distribute up to 200 copies of this document annually, at no charge, for personal and classroom educational use. When printing this document, you may NOT modify it in any way. For any other use, please contact Science Buddies.