Hello,
Greetings.
Kindly sent the corrected document on this project
Assemble the new circuit ...
Diffused Red Led short leg to be connected to F16.. where as we had already connect jumper wires ( 6 total) one in (+) to F16.
Potentiometer as per the document is says D23,D24,D25 where as vedio says D18,D19, D20.
6 wire jumper wires connection I need the correct document
Thanks for your support
Project - colour sensor - To buid a circuit to detect ripe Produce
Moderators: kgudger, bfinio, MadelineB, Moderators
-
- Expert
- Posts: 758
- Joined: Mon Aug 12, 2013 2:41 pm
- Occupation: Science Buddies Staff
- Project Question: Expert
- Project Due Date: n/a
- Project Status: Not applicable
Re: Project - colour sensor - To buid a circuit to detect ripe Produce
Hi sundarlak,
Thank you for catching an error in this project. Some of the values in Table 3 are wrong. They should match what is shown in the diagrams:
Red LED should be long leg to E26, short leg to F26 (not E16 and F16)
Potentiometer should be in D18, D19, D20 (not D23, D24, D25)
I will update the instructions, but the change will not show on our website until next week because of the Christmas and New Year's holidays in the US. In the meantime, please use the values shown in the slideshow.
Thanks,
Ben
Thank you for catching an error in this project. Some of the values in Table 3 are wrong. They should match what is shown in the diagrams:
Red LED should be long leg to E26, short leg to F26 (not E16 and F16)
Potentiometer should be in D18, D19, D20 (not D23, D24, D25)
I will update the instructions, but the change will not show on our website until next week because of the Christmas and New Year's holidays in the US. In the meantime, please use the values shown in the slideshow.
Thanks,
Ben