Interpreting results Boat Density & weight it supports

Ask questions about projects relating to: aerodynamics or hydrodynamics, astronomy, chemistry, electricity, electronics, physics, or engineering

Moderators: AmyCowen, kgudger, bfinio, MadelineB, Moderators

Locked
HFranklin42
Posts: 1
Joined: Tue Jan 28, 2020 11:43 am
Occupation: Teacher

Interpreting results Boat Density & weight it supports

Post by HFranklin42 »

We did the "How much weight can your boat float?" project and are trying to interpret the results. We have 5 boats, the weight each boat supports calculated, and the density of each boat calculated but aren't exactly sure which one is our winner per se. This may be more simple that we realize but can't seem to figure it out. Can anyone help? Thank you!
audreyln
Expert
Posts: 250
Joined: Fri Oct 01, 2010 7:28 am
Occupation: Engineer - Chemical
Project Question: n/a
Project Due Date: n/a
Project Status: Not applicable

Re: Interpreting results Boat Density & weight it supports

Post by audreyln »

Hello,

This sounds like a fun project! If you're looking for a "winner" you can look at which boat held the most pennies (the most weight) before sinking. This should be the boat with the largest volume.

The densities you've calculated for each boat should be about the same (0.7 to 1.3 g/cm3) which is approximately the density of water (1 g/cm3) because each hull will have a density very close to that of water before they sink. See the "What Happened" section at the bottom of the Instructions page for more details. https://www.sciencebuddies.org/stem-act ... structions

Good luck,

Audrey
Locked

Return to “Grades K-5: Physical Science”