Page 1 of 1
Class Project
Posted: Wed Feb 25, 2015 2:41 pm
by rafonja
I want to design a corona discharge separator that can be used to separate fine partcles of metals and plastic from a printed circuit board. Your input will be highly appreciated. Thanks
Re: Class Project
Posted: Fri Feb 27, 2015 12:26 pm
by deleted-2131
Hi rafonja,
Welcome to the Ask an Expert forums! Do you have specific questions about your project?
Re: Class Project
Posted: Fri Feb 27, 2015 1:22 pm
by rafonja
I was wondering if you can suggest any materials and give me instructions on how to create a corona discharge that can be used to separate fine particles of metals from plastic. My plan was to get a small PCB, grind it and separate the metals from the plastic by pass it through a charge. Thanks you.