# How Salty Does the Sea Have to Be for an Egg to Float?

 Areas of Science Ocean Sciences Difficulty Time Required Very Short (≤ 1 day) Prerequisites None Material Availability Readily available Cost Very Low (under \$20) Safety Always wash your hands after handling uncooked eggs because they may carry Salmonella.

## Abstract

Some objects float on top of the ocean, and other objects sink to the bottom. Why? Try this eggsperiment to find out!

## Objective

Determine what salt concentration will float an egg.

## Credits

Andrew Olson, PhD, Science Buddies

Sandra Slutz, PhD, Science Buddies

General citation information is provided here. Be sure to check the formatting, including capitalization, for the method you are using and update your citation, as needed.

### MLA Style

Science Buddies Staff. "How Salty Does the Sea Have to Be for an Egg to Float?" Science Buddies, 20 Nov. 2020, https://www.sciencebuddies.org/science-fair-projects/project-ideas/OceanSci_p003/ocean-sciences/how-salty-does-the-sea-have-to-be-for-an-egg-to-float?from=Newsletter. Accessed 20 June 2021.

### APA Style

Science Buddies Staff. (2020, November 20). How Salty Does the Sea Have to Be for an Egg to Float? Retrieved from https://www.sciencebuddies.org/science-fair-projects/project-ideas/OceanSci_p003/ocean-sciences/how-salty-does-the-sea-have-to-be-for-an-egg-to-float?from=Newsletter

Last edit date: 2020-11-20

## Introduction

Did you know that if you put an egg in a cup of tap water, it will sink to the bottom? But, if you add enough salt, the egg will float back up to the surface! Why? Because the density of the egg is higher than the density of tap water, so it sinks. Density (ρ), as shown in Equation 1, is the mass (m) of a material per unit volume (v). For example, the density of freshwater under standard conditions is approximately 1 gram (g) per cubic centimeter (cm3). In other words, if you filled a 1-cm x 1-cm x 1-cm box with freshwater, the water inside the box would have a mass of 1 g. Adding salt to the water increases the density of the water, because the salt increases the mass without changing the volume very much. With enough added salt, the saltwater solution density is higher than the egg's, and the egg will then float, as shown in Figure 1. The ability of something, like the egg, to float in water or some other liquid is known as buoyancy.

Equation 1:

ρ = Density in whatever units are used for mass and volume.
m = Mass in grams (g), kilograms (kg), or any other unit of weight.
v = Volume in centimeters cubed (cm3), meters cubed (m3), or any other unit of volume.

Figure 1. When an egg is placed in saltwater, if the water is salty enough then the egg will float because the egg's density is less than the density of the saltwater. This picture shows an egg floating in very salty saltwater from two different points of view.

But just how much salt is needed to make an egg float? In this science fair project, you will figure that out by using the technique of making serial dilutions. A serial dilution is a method for accurately diluting a solution in regular steps. You add a known amount of your starting, or stock, solution to a known amount of water and mix them. The new concentration will be determined by the ratio of the volume of stock solution to the total volume, as shown in Equation 2.

Equation 2:

If the volume of stock solution and the volume of water are equal, you will be diluting the solution by half. This is called a two-fold dilution. If you want bigger steps, you should use relatively more water; if you want smaller steps, you should use relatively less water. By repeating the process, you can make a whole series of dilutions, which is how the method got its name. In this ocean science project, you will start out using two-fold dilutions to find out how much salt will cause an egg to float.

## Terms and Concepts

• Density
• Mass
• Volume
• Buoyancy
• Serial dilution
• Stock
• Concentration
• Relative concentration
• Absolute concentration

### Questions

• Why would an egg float in water with a lot of salt in it, but not in plain tap water?
• What happens to salt (sodium chloride or NaCl) molecules when dissolved in water?
• Why does adding salt to water increase its density?

, ,

## Materials and Equipment

• Eggs (5)
• Permanent marker
• Table salt (1 cup)
• Water
• Measuring cup, liquid
• Large container, such as a large bowl or cooking pot. Must be able to hold at least five cups.
• Spoon for stirring
• Bag of clear 16-oz. plastic cups
• Soup spoon for egg transfer
• Lab notebook

## Experimental Procedure

1. Note: For convenience of doing this science project using household measuring tools, volumes are given in terms of United States measuring spoons and cups. However, science is done in metric units and students may need to convert when writing up their procedure. To convert units, you can use the following website:
1. Science Made Simple, Inc. (n.d.). Metric conversions & US customary unit conversion calculator. Retrieved April 15, 2013, from http://www.sciencemadesimple.com/conversions.html
2. Take five eggs out of the refrigerator, use a permanent marker to label them 1-5, and allow them to warm to room temperature.
3. Make a stock solution of 1 cup of salt dissolved in 5 cups of water, as follows:
1. Pour 3 cups of water into your large container.
2. Add 1 cup of salt.
3. Stir to dissolve some of the salt. It will not all dissolve yet.
4. Add 2 more cups of water.
5. Stir to dissolve the rest of the salt. The salt should be completely dissolved before you go on to the next step.
1. This may take several (5 to 10) minutes of stirring, so you may need to be patient.
4. Make a two-fold serial dilution of the stock solution, as follows:
1. Label five of the plastic cups 1-5. Cup 1 will be for the stock solution, cups 2-4 will be for the dilutions, and cup 5 will be plain tap water.
2. Add 3/4 cup of your stock salt solution to cup 1.
3. Add 3/4 cup plain tap water to cups 2-5.
4. Measure out 3/4 cup stock solution, and add it to cup 2. Mix.
5. Measure out 3/4 cup of the solution from cup 2 and add it to cup 3. Mix.
6. Measure out 3/4 cup of the solution from cup 3 and add it to cup 4. Mix.
7. What are the relative salt concentrations of cups 1-4? Example: Cup 2 is made up of half stock solution and half tap water, which is a 50 percent relative salt concentration.
8. What are the absolute salt concentrations of cups 1-4? (If you want to convert to metric units, 1 cup of salt is about 292 grams [g], and 1 cup of water is 237 milliliters [mL].) Write these concentrations down in your lab notebook.
5. Now, starting with cup 5 and working your way up, test an egg in each solution to see if it will float. Use a soup spoon to lift the egg in and out of the cups.
6. In which cup did the egg first float? (Save this solution for step 7.) If the egg floated in more than one cup, did you notice any difference in how it floated?
1. Be sure to record your results and observations in your lab notebook, including the egg's number.
7. Repeat steps 5-6 with four other eggs.
8. Now you know, within a factor of 2, how much salt it takes to float an egg. How can you narrow down the range further to get a more precise estimate? By doing another serial dilution, of course.
9. This time you will start your dilution with the salt concentration in which the egg first floated, the one you selected in step 6.
1. Figure out a new serial dilution with smaller steps. For example, you could try diluting the solution by 25 percent with each step. That means with each step, the new concentration should be 75 percent of the original concentration.
2. What amounts of stock solution and water do you need to use?
1. Remember that you will need enough solution to more than cover the egg, which will probably be around 3/4 cup, and you probably cannot fit more than 2 cups of solution in each 16-oz. cup.
2. Hint: You may only be able to test the first few cups in a dilution series at a time unless you use larger cups.
3. Tip: If you need additional help for making serial dilutions, check out the serial dilutions resource in the Bibliography in the Background section.
3. Write up your new dilution procedure in your lab notebook, including the calculated relative and absolute salt concentrations for each cup.
4. Make the new dilution series. Remember to start with salt concentration where the egg first floated. (If you do not have enough solution from the original serial dilution, make some more by starting from the stock solution.)
10. As before, test an egg in each cup, starting with the lowest salt concentration. In which cup did the egg float first?
1. Be sure to record your results and observations in your lab notebook, including the egg's number.
2. Repeat this step with the four other eggs.
11. If you want, make another dilution series, with even smaller steps, to improve the precision of your estimate.
1. Be sure to record your results and observations in your lab notebook, including the egg's number.
2. Repeat this step with the four other eggs.
12. When you are done handling the eggs, wash your hands with soap and warm water. It is important to wash your hands after handling uncooked eggs because they may carry Salmonella.
13. Determine the densities for all five eggs and record this in your lab notebook.
1. Hint: If the density of the saltwater is less than the egg's density, the egg will sink, and if the density of the saltwater is greater than the egg's density, the egg will float. So the density of the egg would be between these two absolute salt densities.
14. Plot the densities for all five eggs on a chart, putting the egg's number on the x-axis and its density on the y-axis. What is the density of the eggs? How much variation in density is there from egg to egg?
.

## If you like this project, you might enjoy exploring these related careers:

Career Profile
Everything in the environment, whether naturally occurring or of human design, is composed of chemicals. Chemists search for and use new knowledge about chemicals to develop new processes or products. Read more
Career Profile
Water covers more than 70 percent of Earth's surface, and marine architects design vessels that allow humans and their cargo to cross through or under those waters safely and efficiently. Some of their watercraft designs are enormous, like merchant ships, which carry huge loads of oil, cars, food, clothing, toys, and other goods, across thousands of miles of open waters. These ships are essential for trade between countries. Other vessels are smaller and more specialized, like luxury yachts or… Read more
Career Profile
The role that the chemical technician plays is the backbone of every chemical, semiconductor, and pharmaceutical manufacturing operation. Chemical technicians conduct experiments, record data, and help to implement new processes and procedures in the laboratory. If you enjoy hands-on work, then you might be interested in the career of a chemical technician. Read more

## Variations

• Does a hard-boiled egg float at the same salt concentration as an uncooked one? Hint: You will need to measure the same egg before and after hard boiling and be very precise about your serial dilutions.
• Find out how much salt there is in sea water. From the results of your experiment, predict whether an egg would float or sink in sea water. (If you live close enough to the ocean, you can get collect some sea water and test your prediction!)
• Figure out another method of determining the density of an egg. Compare the density measurements for the same eggs using your method and this salt water float test.
• For another way of looking at salt water density, see the Science Buddies project Can Water Float on Water?.

## Share your story with Science Buddies!

The Ask an Expert Forum is intended to be a place where students can go to find answers to science questions that they have been unable to find using other resources. If you have specific questions about your science fair project or science fair, our team of volunteer scientists can help. Our Experts won't do the work for you, but they will make suggestions, offer guidance, and help you troubleshoot.