Test Construction Materials Science Projects (6 results)

Investigate the strength of the nuts and bolts of what goes into buildings. Build your own tools or discover accurate ways to measure concrete strength, nails and screws in wood, or glue performance.

Search Refinements
Go
Cost
Time
Material Availability
Science Fair Project Idea
How much force does it take to drive a nail through different types of wood? In this project you'll build a simple test apparatus to swing a hammer reproducibly so you can find out. Read more
Science Fair Project Idea
How strongly do different types of nails hold in wood? Try different diameters of nails, and try pounding them to different depths. To gauge the holding strength, measure how difficult it is to remove the nail. Can you pull it out with a pair of pliers? Can you remove it with the hammer claw? Do you have to push only a little bit, moderately hard, or as hard as you can? Do you need a crowbar? What happens if you pre-drill holes for the nails, using drill bits that are different… Read more
Science Fair Project Idea
Sorry, you don't get to use a jackhammer for this project, but you'll find out another way to break concrete (not to mention what makes it strongest). Read more
Science Fair Project Idea
Try gluing wood together with different types of glue, e.g.: regular white glue, yellow wood glue, cyanoacrylate (super glue), and Liquid Nails. Glue a short piece (5-8 cm) to the center of a longer piece (15-30 cm). After the glue has dried for the recommended time, drill a small hole through the center of the joint, big enough to pass through a piece of coat-hanger wire. Cut a length of coat hanger wire, pass it through the hole, and twist the ends together to form a loop. Place the ends… Read more
Science Fair Project Idea
There are many types of construction materials used for wood-frame houses. Compare the different uses for and strengths of different building materials, e.g.: particle board, plywood, pine, oriented strand board (OSB), and drywall (gypsum board, SheetRock). The Science Buddies Materials Science Resource Stress, Strength and Strain will be helpful for learning about different ways to measure material strength. You should be sure to use the same cross-sectional area of each material in order… Read more
Science Fair Project Idea
How much force is required to advance a lag bolt (large wood screw with a hex-shaped head) into a piece of wood? You can measure the force by using a spring scale attached to the handle of ratchet. Pull on the spring scale until the bolt starts to turn, and note the required force from the spring scale. There are many potential experiments you could try. Think about answering the following questions: How does the force change as the bolt advances deeper into the wood? Why? How does the… Read more
1
Free science fair projects.