Hi everyone
I'm doing a chemistry investigation on how peas are prepared (frozen,fresh,canned,dried)affect how much vitamin c are in the peas.I'm doing the iodine back titration that involves sodium thiosulfate as the standard solution the concentration of the sodium thiosulfate solution is (0.100molL).I don't know how many peas i should use to titrate with the sodium thiosulfate solution and how much water i should add with the peas.Can someone please help me?
vitamin c titrations
-
deleted-2131
- Former Expert
- Posts: 1415
- Joined: Sat Nov 08, 2003 11:27 pm
- Occupation: Planetary Scientist
- Project Question: N/A
- Project Due Date: N/A
- Project Status: Not applicable
-
deleted-2131
- Former Expert
- Posts: 1415
- Joined: Sat Nov 08, 2003 11:27 pm
- Occupation: Planetary Scientist
- Project Question: N/A
- Project Due Date: N/A
- Project Status: Not applicable
In the research that I did, it appears that the amount of juice used doesn't really matter. I came across one protocol which said the following:
Fruit juice
For juices or fresh fruits, titrate 50 mL of juice.
If you are squeezing fresh juice or using a pulpy juice, strain out most of the pulp. Place two squares
of cheesecloth over a 150-mL beaker. While holding the cheesecloth in one hand, pour the juice ontothe cheesecloth (use a mortar and pestle if necessary to get all the juice out of the fruit). After most
of the liquid has passed through the cloth, bring the edges of the cloth up to make a sack of the
watery pulp. Gently press out the remaining liquid into the beaker. Measure the amount of liquid
collected in a graduated cylinder (you will calculate the mass of ascorbic acid per mL of juice).
Transfer the juice to a 250-mL Erlenmeyer flask. Add the KI, HCl and starch as before, and titrate
with the KIO3.
With the juices, it sometimes takes a little longer for the blue color to fade. In this case, the endpoint
is where the color is permanent.
The full description can be found at:
test-2.media.berkeley.edu/ ~chem1b/spring05/Lab/pdf/lab5.pdf
Fruit juice
For juices or fresh fruits, titrate 50 mL of juice.
If you are squeezing fresh juice or using a pulpy juice, strain out most of the pulp. Place two squares
of cheesecloth over a 150-mL beaker. While holding the cheesecloth in one hand, pour the juice ontothe cheesecloth (use a mortar and pestle if necessary to get all the juice out of the fruit). After most
of the liquid has passed through the cloth, bring the edges of the cloth up to make a sack of the
watery pulp. Gently press out the remaining liquid into the beaker. Measure the amount of liquid
collected in a graduated cylinder (you will calculate the mass of ascorbic acid per mL of juice).
Transfer the juice to a 250-mL Erlenmeyer flask. Add the KI, HCl and starch as before, and titrate
with the KIO3.
With the juices, it sometimes takes a little longer for the blue color to fade. In this case, the endpoint
is where the color is permanent.
The full description can be found at:
test-2.media.berkeley.edu/ ~chem1b/spring05/Lab/pdf/lab5.pdf
All the best,
Terik
Terik
-
JULIE ANN BONSUBRE
- Posts: 31
- Joined: Sun Sep 05, 2004 8:22 pm
Try this:
http://chemmovies.unl.edu/chemistry/bec ... BD047.html
Or
http://www.vitaminresourcelist.com/10/v ... ation.html
good luck!
Teacher
PNHS, Philippines
PNHS, Philippines

