Mass/ Gravity Question
Moderators: AmyCowen, kgudger, bfinio, MadelineB, Moderators
-
rachelp4
- Posts: 1
- Joined: Thu May 07, 2015 1:45 pm
- Occupation: Student: 7th grade
- Project Question: In my science fair project I am testing the weight bearing capacities of three types of truss bridges. I have already finished the experiment and I am now analyzing my data. I am trying to figure out how to find the strength-weight ratio. I know what the formula is, but cannot figure out the mass of the bridge and the bridge load.
- Project Due Date: 5/8/15
- Project Status: I am finished with my experiment and analyzing the data
Mass/ Gravity Question
In my experiment, I need to find the strength-weight ratio for a popsicle stick bridge. I know the formula to change weight into mass. After that I need to divide that number by the gravity on earth. On one website it said that gravity was a constant 9.78 m/s2. But then another website said it is 9.81 m/s2. I don't know which one to believe, and I am just doing some last minute tweaking before my science fair tomorrow.
-
deleted-249560
- Posts: 496
- Joined: Thu Nov 20, 2014 1:35 pm
- Occupation: Science Buddies content developer
- Project Question: N/A
- Project Due Date: N/A
- Project Status: Not applicable
Re: Mass/ Gravity Question
Both are correct, depending on where you are. The earth isn't exactly round, so the 9.78 figure is accurate at the equator and at sea level, where the 9.81 figure is at the poles. Most formulas use 9.8 as the figure for those of us standing on a typical earth surface that's neither known for being high or low. You'll be fine using any number in that range. In your notebook just say it's a range and used the common average - that should cover you.
Howard
Howard
-
bradleyshanrock-solberg
- Former Expert
- Posts: 260
- Joined: Thu Aug 25, 2005 7:44 am
- Occupation: Software Engineer/QA Lead - Quality, Risk Assessment, Statistics, Problem Solving
- Project Question: BS Caltech Engineering & Applied Science (Mechanical Engineering, Materials Science)
Research in Traffic and Ceramic Composites
25 years doing IT, various roles, for multinational manufacturing company - Project Due Date: n/a
- Project Status: Not applicable
Re: Mass/ Gravity Question
Alternately you can just use two "significant digits" and call it 9.8
When you do this, it is important that all calculated values using this number only have 2 digits of precision (so a result of 121.324 would be reported as 120)
It is a common problem in science that the precision of your results sometimes has a value that is only as precise as the tool you use to measure it. When this happens, you have to put all of your results at the same precision as your worst tool. If you know which value fits where you are standing when you do the experiment, you can use the higher precision (3 digit) number.
When you do this, it is important that all calculated values using this number only have 2 digits of precision (so a result of 121.324 would be reported as 120)
It is a common problem in science that the precision of your results sometimes has a value that is only as precise as the tool you use to measure it. When this happens, you have to put all of your results at the same precision as your worst tool. If you know which value fits where you are standing when you do the experiment, you can use the higher precision (3 digit) number.

