How can I test the bacterial content in water and identify the bacteria at a reasonable cost?
Thanks for your help!!
Identifying bacteria in Water
-
Bob.Burkhart
- Former Expert
- Posts: 26
- Joined: Tue Oct 03, 2006 12:04 pm
The Perfect Site
This site contains instructions on a variety of methods including for people who don't necessarily have the required equipment for more accurate counts:
http://www.disknet.com/indiana_biolab/b038.htm
Good luck!
http://www.disknet.com/indiana_biolab/b038.htm
Good luck!
Hope this helps,
-Bob-
-Bob-
-
Louise
- Former Expert
- Posts: 921
- Joined: Mon Jan 16, 2006 2:17 pm
Re: Identifying bacteria in Water
This is the same question you asked in the physical science forum- you got several detailed suggestions over there. You should use this information to formulate more specific questions, not just ask the same question over again!monanejad wrote:How can I test the bacterial content in water and identify the bacteria at a reasonable cost?
Thanks for your help!!
Louise
-
soundwave990
- Former Expert
- Posts: 53
- Joined: Wed Sep 27, 2006 3:04 pm
-
johnmei3
- Former Expert
- Posts: 1
- Joined: Sun Oct 22, 2006 8:42 pm
Bacterial Content Testing
Monanejad,
A good way to start off is to procure maybe a 3L sample of your water, to make sure you have enough for bacterial tests. Next, you can run your water through a filter. This is done typically with a dual-chambered device: a controlled amount of water is poured into the first chamber, a vacuum is attached to the second chamber, and filter paper separates the two chambers. The filter paper has about 0.22 micron pores. This way the bacteria are attached to the filter paper, while the water runs through. There are also 0.5 micron and 0.9 micron filter papers; it depends on what kind of bacteria you seek to identify and count.
When the filtration process is completed, you can just put the filter paper onto agar, face down so the bacteria side faces the agar.
Another word of caution, if you are to use this procedure: test different quantities of water to filter, because bacterial concentration may vary a great deal from source to source. If the bacterial concentration is too high, you see a lawn on your agar; too low, you see nothing.
A good way to start off is to procure maybe a 3L sample of your water, to make sure you have enough for bacterial tests. Next, you can run your water through a filter. This is done typically with a dual-chambered device: a controlled amount of water is poured into the first chamber, a vacuum is attached to the second chamber, and filter paper separates the two chambers. The filter paper has about 0.22 micron pores. This way the bacteria are attached to the filter paper, while the water runs through. There are also 0.5 micron and 0.9 micron filter papers; it depends on what kind of bacteria you seek to identify and count.
When the filtration process is completed, you can just put the filter paper onto agar, face down so the bacteria side faces the agar.
Another word of caution, if you are to use this procedure: test different quantities of water to filter, because bacterial concentration may vary a great deal from source to source. If the bacterial concentration is too high, you see a lawn on your agar; too low, you see nothing.
-
soundwave990
- Former Expert
- Posts: 53
- Joined: Wed Sep 27, 2006 3:04 pm
hey there
sorry i forgot to post the website for help for your topic
http://www.aai.org/committees/education ... stesen.pdf
sorry i forgot to post the website for help for your topic
http://www.aai.org/committees/education ... stesen.pdf
I hope this helps and good luck with your project
-JR
Volunteer Mentor for Ask An Expert Forum
-JR
Volunteer Mentor for Ask An Expert Forum

