Identifying bacteria in Water

Ask questions about projects relating to: biology, biochemistry, genomics, microbiology, molecular biology, pharmacology/toxicology, zoology, human behavior, archeology, anthropology, political science, sociology, geology, environmental science, oceanography, seismology, weather, or atmosphere.
Locked
monanejad
Posts: 10
Joined: Tue Oct 10, 2006 9:25 pm

Identifying bacteria in Water

Post by monanejad »

How can I test the bacterial content in water and identify the bacteria at a reasonable cost?

Thanks for your help!!
Bob.Burkhart
Former Expert
Posts: 26
Joined: Tue Oct 03, 2006 12:04 pm

The Perfect Site

Post by Bob.Burkhart »

This site contains instructions on a variety of methods including for people who don't necessarily have the required equipment for more accurate counts:
http://www.disknet.com/indiana_biolab/b038.htm

Good luck!
Hope this helps,
-Bob-
Louise
Former Expert
Posts: 921
Joined: Mon Jan 16, 2006 2:17 pm

Re: Identifying bacteria in Water

Post by Louise »

monanejad wrote:How can I test the bacterial content in water and identify the bacteria at a reasonable cost?

Thanks for your help!!
This is the same question you asked in the physical science forum- you got several detailed suggestions over there. You should use this information to formulate more specific questions, not just ask the same question over again! :lol:


Louise
soundwave990
Former Expert
Posts: 53
Joined: Wed Sep 27, 2006 3:04 pm

Post by soundwave990 »

hey there

try checkin out this pdf file it has different procedures of how to deal with cultures of bacteria and agar dishes...there are about 40 pgs of info im sure it may help at least a lil bit
I hope this helps and good luck with your project
-JR
Volunteer Mentor for Ask An Expert Forum
johnmei3
Former Expert
Posts: 1
Joined: Sun Oct 22, 2006 8:42 pm

Bacterial Content Testing

Post by johnmei3 »

Monanejad,
A good way to start off is to procure maybe a 3L sample of your water, to make sure you have enough for bacterial tests. Next, you can run your water through a filter. This is done typically with a dual-chambered device: a controlled amount of water is poured into the first chamber, a vacuum is attached to the second chamber, and filter paper separates the two chambers. The filter paper has about 0.22 micron pores. This way the bacteria are attached to the filter paper, while the water runs through. There are also 0.5 micron and 0.9 micron filter papers; it depends on what kind of bacteria you seek to identify and count.
When the filtration process is completed, you can just put the filter paper onto agar, face down so the bacteria side faces the agar.
Another word of caution, if you are to use this procedure: test different quantities of water to filter, because bacterial concentration may vary a great deal from source to source. If the bacterial concentration is too high, you see a lawn on your agar; too low, you see nothing.
soundwave990
Former Expert
Posts: 53
Joined: Wed Sep 27, 2006 3:04 pm

Post by soundwave990 »

hey there

sorry i forgot to post the website for help for your topic

http://www.aai.org/committees/education ... stesen.pdf
I hope this helps and good luck with your project
-JR
Volunteer Mentor for Ask An Expert Forum
Locked

Return to “Life, Earth, and Social Sciences”