Experiment in Civil Engineering Science Projects (21 results)
|
Using just a single sheet of paper (8.5 x 11 inches) and up to five paper clips, can you build a bridge that will span 20 cm and support the weight of 100 pennies? The area beneath the span must be free (so that boats can pass beneath it). To test your bridge, place two books 20 cm apart, and set the bridge on the books, spanning the gap. Do not fasten the bridge to the book (nor to any other support). Does your bridge hold as much weight as you expected it would? If your bridge fails…
Read more
How much force does it take to drive a nail through different types of wood? In this project you'll build a simple test apparatus to swing a hammer reproducibly so you can find out.
Read more
Predict how tall you can build a tower using only two sheets of newspaper as building material. You can't use tape, glue, staples, or anything else, just two sheets of newspaper. You can tear, bend, cut, or fold the newspaper. Try it out and see how close you can come to your prediction. Can you beat your prediction? As you're building, you may come up with ideas to make a better tower. Try them out! (It's not like the materials are expensive!) Here are some variations you might want to…
Read more
Foundations for many types of structures rest on soil. This project shows how you can investigate the bearing capacity of different types of soil.
Read more
Start with 7 drinking straws and 14 paper clips. Use the paper clips to fasten the straws together. Here's how: 1) Clip two paper clips together, narrow end to narrow end. 2) Push the wide ends of each clip into the end of a straw. That's it! Connect four straws to make a square, and three straws to make a triangle. Now test which shape is stronger. Hold the shapes vertically, with an edge or a vertex resting on the tabletop. Have a helper push on the opposite side or vertex. Which shape…
Read more
Try gluing wood together with different types of glue, e.g.: regular white glue, yellow wood glue, cyanoacrylate (super glue), and Liquid Nails. Glue a short piece (5-8 cm) to the center of a longer piece (15-30 cm). After the glue has dried for the recommended time, drill a small hole through the center of the joint, big enough to pass through a piece of coat-hanger wire. Cut a length of coat hanger wire, pass it through the hole, and twist the ends together to form a loop. Place the ends…
Read more
Sorry, you don't get to use a jackhammer for this project, but you'll find out another way to break concrete (not to mention what makes it strongest).
Read more
Here's a fun project idea to learn about compression forces. For this experiment you'll need some empty toilet paper tubes, masking tape, sand (or table salt), pebbles (or marbles), a funnel, a cardboard box, and a sturdy chair to help you balance while testing the column. Seal one end of the tube with masking tape. Use the funnel to fill the tube with sand (or salt). Seal the other end with tape. Place the tube on end inside the paper box. Place the chair with its back to the box and hold…
Read more
There are many types of construction materials used for wood-frame houses. Compare the different uses for and strengths of different building materials, e.g.: particle board,
plywood, pine, oriented strand board (OSB), and drywall (gypsum board, SheetRock). The Science Buddies Materials Science Resource Stress, Strength and Strain will be helpful for learning about different ways to measure material strength. You should be sure to use the same cross-sectional area of each material in order…
Read more
How much force is required to advance a lag bolt (large wood screw with a hex-shaped head) into a piece of wood? You can measure the force by using a spring scale attached to the handle of ratchet. Pull on the spring scale until the bolt starts to turn, and note the required force from the spring scale. There are many potential experiments you could try. Think about answering the following questions: How does the force change as the bolt advances deeper into the wood? Why? How does the…
Read more
|








