Explore Structural Engineering Science Projects (15 results)

Using just a single sheet of paper (8.5 x 11 inches) and up to five paper clips, can you build a bridge that will span 20 cm and support the weight of 100 pennies? The area beneath the span must be free (so that boats can pass beneath it). To test your bridge, place two books 20 cm apart, and set the bridge on the books, spanning the gap. Do not fasten the bridge to the book (nor to any other support). Does your bridge hold as much weight as you expected it would? If your bridge fails… Read more

On December 26, 2004, a magnitude 9.2 megathrust earthquake off the west coast of Sumatra, Indonesia unleashed a powerful tsunami that hit the coasts of 14 countries and caused the loss of over 200,000 lives. The devastation that the tsunami left in its wake was heartbreaking, and people across the world united to help the survivors. Tsunamis are a powerful force of nature that can change the features of a coastline and result in millions of dollars in economic loss, but can… Read more

Predict how tall you can build a tower using only two sheets of newspaper as building material. You can't use tape, glue, staples, or anything else, just two sheets of newspaper. You can tear, bend, cut, or fold the newspaper. Try it out and see how close you can come to your prediction. Can you beat your prediction? As you're building, you may come up with ideas to make a better tower. Try them out! (It's not like the materials are expensive!) Here are some variations you might want to… Read more

Start with 7 drinking straws and 14 paper clips. Use the paper clips to fasten the straws together. Here's how: 1) Clip two paper clips together, narrow end to narrow end. 2) Push the wide ends of each clip into the end of a straw. That's it! Connect four straws to make a square, and three straws to make a triangle. Now test which shape is stronger. Hold the shapes vertically, with an edge or a vertex resting on the tabletop. Have a helper push on the opposite side or vertex. Which shape… Read more

Here's a fun project idea to learn about compression forces. For this experiment you'll need some empty toilet paper tubes, masking tape, sand (or table salt), pebbles (or marbles), a funnel, a cardboard box, and a sturdy chair to help you balance while testing the column. Seal one end of the tube with masking tape. Use the funnel to fill the tube with sand (or salt). Seal the other end with tape. Place the tube on end inside the paper box. Place the chair with its back to the box and hold… Read more