Design an audio amplifier ( class AB output stage) ICs are not allowed.
load resistance is 10 ohm.Max.gain in mid band should be greater or equal to 300.
output swing should be 10 volt peak. input impedance should be 10K ohm.lower frequency should be less than or equal to 10 hertz. higher frequency should be greater or equal to 30KHz.
DC output voltage less than or equal to 100mV. quiescent current less than or equal to 10mA.
AUDIO AMPLIFIER
-
Aqeel
- Posts: 2
- Joined: Sun Nov 17, 2013 8:18 am
- Occupation: "Student:B.Sc Electrical Engineering"
- Project Question: Design an audio amplifier ( class AB output stage) ICs are not allowed.
load resistance is 10 ohm.Max.gain in mid band should be greater or equal to 300.
output swing should be 10 volt peak. input impedance should be 10K ohm.lower frequency should be less than or equal to 10 hertz. higher frequency should be greater or equal to 30KHz.
DC output voltage less than or equal to 100mV. quiescent current less than or equal to 10mA. - Project Due Date: 30th November 2013
- Project Status: I am just starting
-
k4gfwgerry
- Former Expert
- Posts: 70
- Joined: Wed Jul 06, 2011 12:35 pm
- Occupation: Retired Electronics Engineer from Motorola Solutions
- Project Question: n/a
- Project Due Date: n/a
- Project Status: Not applicable
Re: AUDIO AMPLIFIER
Take a look at the following web site: http://www.circuitstoday.com/few-transi ... r-circuits. This circuit uses no ICs. I would suggest varying the component values to meet the parameters that you listed. Good Luck.
Gerry Gruenbaum
Science Buddies "Ask an Expert" Volunteer
Science Buddies "Ask an Expert" Volunteer
-
Aqeel
- Posts: 2
- Joined: Sun Nov 17, 2013 8:18 am
- Occupation: "Student:B.Sc Electrical Engineering"
- Project Question: Design an audio amplifier ( class AB output stage) ICs are not allowed.
load resistance is 10 ohm.Max.gain in mid band should be greater or equal to 300.
output swing should be 10 volt peak. input impedance should be 10K ohm.lower frequency should be less than or equal to 10 hertz. higher frequency should be greater or equal to 30KHz.
DC output voltage less than or equal to 100mV. quiescent current less than or equal to 10mA. - Project Due Date: 30th November 2013
- Project Status: I am just starting
Re: AUDIO AMPLIFIER
give me an idea to use darlington pair based class ab output stagek4gfwgerry wrote:Take a look at the following web site: http://www.circuitstoday.com/few-transi ... r-circuits. This circuit uses no ICs. I would suggest varying the component values to meet the parameters that you listed. Good Luck.