Build a Bridge Science Projects (5 results)

Build model bridges and then deliberately destroy them? Who'd be crazy enough to try that? Read more

Suspension bridges, with their tall towers, long spans, and gracefully curving cables, are beautiful examples of the work of civil engineers. How do the cables and towers carry the load that is on the bridge? Can a suspension bridge carry a greater load than a simple beam bridge? This science project shows you how to find out. Read more

This is an interesting project that explores which geometrical shapes make the strongest bridge truss structures. It is a good introduction to the engineering design process. You'll design three different trusses, and use online simulation software to analyze the distribution of load-bearing forces in each design. Then you'll build and test prototypes of each design. Read more

A bridge collapse, like that of the I-35W Mississippi River Bridge, can be a major disaster. Bridges that cannot hold enough weight to do their intended job can be a serious public safety issue. And if they collapse, they can also cause economic damage due to costly rebuilding and people and companies scrambling to figure out how to circumvent the months of traffic impacts. Figure 1. On August 1, 2007 the I-35W Mississippi River Bridge collapsed killing 13… Read more

Using just a single sheet of paper (8.5 x 11 inches) and up to five paper clips, can you build a bridge that will span 20 cm and support the weight of 100 pennies? The area beneath the span must be free (so that boats can pass beneath it). To test your bridge, place two books 20 cm apart, and set the bridge on the books, spanning the gap. Do not fasten the bridge to the book (nor to any other support). Does your bridge hold as much weight as you expected it would? If your bridge fails… Read more