Second Grade, Civil Engineering Science Experiments (35 results)
|
Select a resource
Sort by
|
This is an interesting project that explores which geometrical shapes make the strongest bridge truss structures. It is a good introduction to the engineering design process. You'll design three different trusses, and use online simulation software to analyze the distribution of load-bearing forces in each design. Then you'll build and test prototypes of each design.
Read more
A bridge collapse, like that of the I-35W Mississippi River Bridge, can be a major disaster. Bridges that cannot hold enough weight to do their intended job can be a serious public safety issue. And if they collapse, they can also cause economic damage due to costly rebuilding and people and companies scrambling to figure out how to circumvent the months of traffic impacts.
Figure 1.
On August 1, 2007 the I-35W Mississippi River Bridge collapsed killing 13…
Read more
Have you ever looked up at a skyscraper and thought "That is so cool!"? Building a skyscraper, or any structure, is more than just building the walls, windows, and floors. All structures require a foundation to keep them from falling down. This is especially important when a structure is built on a hill or on a slope. In this science project, you will build a tower of Lego® Duplos® on slopes with different angles. You will investigate how deep you have to dig the foundation for each…
Read more
Here's a fun project idea to learn about compression forces. For this experiment you'll need some empty toilet paper tubes, masking tape, sand (or table salt), pebbles (or marbles), a funnel, a cardboard box, and a sturdy chair to help you balance while testing the column. Seal one end of the tube with masking tape. Use the funnel to fill the tube with sand (or salt). Seal the other end with tape. Place the tube on end inside the paper box. Place the chair with its back to the box and hold…
Read more
How strongly do different types of nails hold in wood? Try different diameters of nails, and try pounding them to different depths. To gauge the holding strength, measure how difficult it is to remove the nail. Can you pull it out with a pair of pliers? Can you remove it with the hammer claw? Do you have to push only a little bit, moderately hard, or as hard as you can? Do you need a crowbar? What happens if you pre-drill holes for the nails, using drill bits that are different…
Read more
Sorry, you don't get to use a jackhammer for this project, but you'll find out another way to break concrete (not to mention what makes it strongest).
Read more
Do you think a sandcastle can support a brick? How can you change a sandcastle to make it support more weight? Find out in this fun science project!
Read more
Predict how tall you can build a tower using only two sheets of newspaper as building material. You can't use tape, glue, staples, or anything else, just two sheets of newspaper. You can tear, bend, cut, or fold the newspaper. Try it out and see how close you can come to your prediction. Can you beat your prediction? As you're building, you may come up with ideas to make a better tower. Try them out! (It's not like the materials are expensive!) Here are some variations you might want to…
Read more
Start with 7 drinking straws and 14 paper clips. Use the paper clips to fasten the straws together. Here's how: 1) Clip two paper clips together, narrow end to narrow end. 2) Push the wide ends of each clip into the end of a straw. That's it! Connect four straws to make a square, and three straws to make a triangle. Now test which shape is stronger. Hold the shapes vertically, with an edge or a vertex resting on the tabletop. Have a helper push on the opposite side or vertex. Which shape…
Read more
Foundations for many types of structures rest on soil. This project shows how you can investigate the bearing capacity of different types of soil.
Read more
|











