Industry, Innovation and Infrastructure, Tenth Grade, Electricity & Electronics Science Projects (24 results)

Measuring the value of a resistor with a multimeter is pretty simple. You set the multimeter to measure resistance, connect the two leads to the resistor (possibly using some handy alligator clips), and read the resistance value. This is called a two-point measurement (one probe on each of the two resistor leads). But what if the resistance you want to measure is very small, in the milli or micro-ohm (mΩ or μΩ) range? This can introduce problems because many low-cost multimeters… Read more

Have you ever worn a costume that lit up or played sound? Have you ever wished you had a suit of armor with built-in moving parts like a superhero? What if you could make your costume or suit react to your own movements or even other people who bump into you? The Science Buddies activity Weaving a Wearable Touch Sensor shows you how to make a capacitive sensor that responds to touch and can be woven directly into fabric (Figure 1). Can you design a piece of clothing that includes one… Read more

Put a meter stick on the ground. Starting at one end of the stick, close your eyes and try to walk exactly one meter. Open your eyes. How close were you? Now try it again with five, ten, or twenty meters. Does it get harder as the distance gets bigger? Without an outside reference from your visual system, it's quite difficult to know exactly how far you've gone! Electronic navigation systems face the same problem. Without an external reference like the global positioning system (GPS), it's very… Read more

If you have ever built an electronic circuit with a soldering iron, you know that the component leads get hot. How much of that heat gets into the device you're soldering? This project shows you how you can use a silicon diode as a temperature sensor to find out. Read more