Middle School, Space Exploration Science Experiments (Page 7)

Build an Arduino Robot

Science Fair Project Idea

Engineering Design Process

The Science Buddies Bluebot Kit contains parts to build four different robots: A motion-activated robot that uses a passive infrared (PIR) sensor A light-tracking robot that uses photoresistors A line-following robot that uses infrared emitter-detectors An obstacle-avoiding robot that uses bump sensors However, in each project, the sensors are hard-wired to control the robot's motors. This allows the robot to steer left and right based on input from two sensors, but it does not allow the… Read more

Build an Autonomous Arduino Robot with Bump Sensors

Science Fair Project Idea

Scientific Method

Mechanical switches are common in many machines and robots. They can be used to detect when a button is pushed, when a door is open, or a low-speed collision when two objects bump into each other. Switches can act as "bump sensors" on a simple robot to help it detect when it hits an obstacle. The robot can use this information to navigate around obstacles and avoid getting stuck. Can you build and program a robot that can drive around your house while using bump sensors to avoid obstacles? Read more

Correlation of Coronal Mass Ejections with the Solar Sunspot Cycle

Science Fair Project Idea

Scientific Method

Scientists have known for hundreds of years that sunspot activity waxes and wanes over a cycle that lasts approximately 11 years. In the 1970's, scientists discovered that the sun periodically blasts electrified gases into space, in huge outbursts called 'coronal mass ejections,' or CMEs. This project asks the question: do CMEs follow the solar sunspot cycle? Read more

Keep Your Arduino Robot From Falling Off a Cliff

Science Fair Project Idea

Engineering Design Process

Humans cannot see infrared light, but robots can! At least, they can when they use special infrared light sensors. These sensors can help robots detect nearby objects to avoid collisions and even help them avoid driving off edges. In this project you will build your own Arduino robot that uses infrared sensors to avoid driving off the edge of a table. Read more

Space Elevator Problem Set

STEM Activity

1

2

3

4

5

9 reviews

Space elevators zipping people and materials up into space might seem like a very futuristic and improbable idea, but is it that difficult? This activity will guide you through the mathematics. Try it out and see what is possible with materials that can be produced with current technology. Read more

Tracking Geomagnetic Storms in the Ionosphere

Science Fair Project Idea

Scientific Method

The Sun is the ultimate source of the energy that powers weather systems on Earth. Geomagnetic storms are sun-powered storms in the upper atmosphere, arising from energized particles that are periodically ejected by the Sun. Among other effects, geomagnetic storms can wreak havoc with earth-orbiting satellites, and disrupt satellite communications. The global positioning system (GPS) is a network of 24 earth-orbiting satellites that constantly sends radio signals through the earth's… Read more

Using the Solar & Heliospheric Observatory Satellite (SOHO) to Determine the Rotation of the Sun

Science Fair Project Idea

Scientific Method

Here's a cool project that shows you how to use images from an orbiting observatory to measure how fast the Sun rotates. Read more

What is the Cheapest Way to Launch Payloads into Space?

Science Fair Project Idea

Engineering Design Process

A mass driver is a proposed device that could launch payloads into space using a long tube lined with electromagnets (Figure 1). Some scientists argue that such a launch system would offer long-term cost savings over the use of chemical rockets. Scientists have proposed theoretical electromagnetic launcher designs as far back as the 1970s (O'Neill 1979). More recently, some have proposed the use of railguns originally developed for the U.S. Navy (McNab and McGlasson 2022). Other types of… Read more

Build a Wearable Device Using an Arduino to Keep Astronauts Safe on Mars

Science Fair Project Idea

Engineering Design Process

Astronauts on Mars missions must be protected from hazardous environments, like steep cliffs, rocky terrain, and extreme temperature variations. How can geofencing help? In this project, you will design a system that uses geofencing technology coupled with biosensors to ensure astronaut safety. The system will create a virtual boundary around astronauts, providing alerts if they approach dangerous areas or leave designated safe zones, or if their vital signs fall below a certain threshold. Can… Read more

Build an Ion Wind Rotor

STEM Activity

1

2

3

4

5

3 reviews