Civil Engineering Science Projects (26 results)
|
Select a resource
Coding Projects
Sort by
|
Have you ever seen a geodesic dome? Geodesic domes are approximately sphere-like (or partially sphere-like) structures made up of interconnected triangles. A famous geodesic dome is Spaceship Earth at EPCOT in Walt Disney World, Florida, but geodesic domes are also commonly found as climbing domes at playgrounds. In this science project, you will get to build a geodesic dome using rolled-up newspapers and tape. How much mass do you think your dome will be able to support? Build one and find out!
Read more
Foundations for many types of structures rest on soil. This project shows how you can investigate the bearing capacity of different types of soil.
Read more
A bridge collapse, like that of the I-35W Mississippi River Bridge, can be a major disaster. Bridges that cannot hold enough weight to do their intended job can be a serious public safety issue. And if they collapse, they can also cause economic damage due to costly rebuilding and people and companies scrambling to figure out how to circumvent the months of traffic impacts.
Figure 1.
On August 1, 2007 the I-35W Mississippi River Bridge collapsed killing 13…
Read more
Start with 7 drinking straws and 14 paper clips. Use the paper clips to fasten the straws together. Here's how: 1) Clip two paper clips together, narrow end to narrow end. 2) Push the wide ends of each clip into the end of a straw. That's it! Connect four straws to make a square, and three straws to make a triangle. Now test which shape is stronger. Hold the shapes vertically, with an edge or a vertex resting on the tabletop. Have a helper push on the opposite side or vertex. Which shape…
Read more
Using just a single sheet of paper (8.5 x 11 inches) and up to five paper clips, can you build a bridge that will span 20 cm and support the weight of 100 pennies? The area beneath the span must be free (so that boats can pass beneath it). To test your bridge, place two books 20 cm apart, and set the bridge on the books, spanning the gap. Do not fasten the bridge to the book (nor to any other support). Does your bridge hold as much weight as you expected it would? If your bridge fails…
Read more
The idea of a colony on Mars is exciting! In this science project, you will tackle one of the challenges a Martian colony will face: what will buildings on Mars be made of? In this project, you will make bricks from Martian-like ground cover and measure how strong these bricks are.
Read more
Do you think a sandcastle can support a brick? How can you change a sandcastle to make it support more weight? Find out in this fun science project!
Read more
Have you ever looked up at a skyscraper and thought "That is so cool!"? Building a skyscraper, or any structure, is more than just building the walls, windows, and floors. All structures require a foundation to keep them from falling down. This is especially important when a structure is built on a hill or on a slope. In this science project, you will build a tower of Lego® Duplos® on slopes with different angles. You will investigate how deep you have to dig the foundation for each…
Read more
Predict how tall you can build a tower using only two sheets of newspaper as building material. You can't use tape, glue, staples, or anything else, just two sheets of newspaper. You can tear, bend, cut, or fold the newspaper. Try it out and see how close you can come to your prediction. Can you beat your prediction? As you're building, you may come up with ideas to make a better tower. Try them out! (It's not like the materials are expensive!) Here are some variations you might want to…
Read more
Here's a fun project idea to learn about compression forces. For this experiment you'll need some empty toilet paper tubes, masking tape, sand (or table salt), pebbles (or marbles), a funnel, a cardboard box, and a sturdy chair to help you balance while testing the column. Seal one end of the tube with masking tape. Use the funnel to fill the tube with sand (or salt). Seal the other end with tape. Place the tube on end inside the paper box. Place the chair with its back to the box and hold…
Read more
|











