Industry, Innovation and Infrastructure, Eleventh Grade, Robotics Science Projects (15 results)

The Science Buddies Bluebot Kit contains parts to build four different robots: A motion-activated robot that uses a passive infrared (PIR) sensor A light-tracking robot that uses photoresistors A line-following robot that uses infrared emitter-detectors An obstacle-avoiding robot that uses bump sensors However, in each project, the sensors are hard-wired to control the robot's motors. This allows the robot to steer left and right based on input from two sensors, but it does not allow the… Read more

Mechanical switches are common in many machines and robots. They can be used to detect when a button is pushed, when a door is open, or a low-speed collision when two objects bump into each other. Switches can act as "bump sensors" on a simple robot to help it detect when it hits an obstacle. The robot can use this information to navigate around obstacles and avoid getting stuck. Can you build and program a robot that can drive around your house while using bump sensors to avoid obstacles? Read more

Humans cannot see infrared light, but robots can! At least, they can when they use special infrared light sensors. These sensors can help robots detect nearby objects to avoid collisions and even help them avoid driving off edges. In this project you will build your own Arduino robot that uses infrared sensors to avoid driving off the edge of a table. Read more

Note: to do this project you will need the DIY Mini Drone Kit, available from our partner Home Science Tools®. An Arduino must be purchased separately. The Electronics Kit for Arduino, available from our partner Home Science Tools®, contains the additional parts you will need, including an ultrasonic sensor. The program in the DIY Mini Drone: Arduino™ Altitude Control project uses a proportional controller to control the drone's altitude. A potentiometer is connected to one… Read more

Check out the soft robotic gripper and artificial robotic skin projects. These projects show you how to use flexible silicone rubber to make robots or robotic parts. The second project shows you how to connect external LEDs using an Arduino. The LEDs light up when an embedded piece of conductive fabric stretches. What about embedding LEDs in the silicone rubber? You can do this by embedding the LEDs between layers of silicone (Figure 1). The trick is to solder flexible stranded wires to the… Read more