Fifth Grade Science Projects (603 results)
|
Select a resource
Coding Projects
Sort by
|
Pennies are bright and shiny when they are new, but become quite dull with time. What causes such a drastic change? Oxygen in the air combines with the copper in the penny to form copper oxide, which makes the penny look dull and dingy. You can make the pennies look like new again by soaking them in water that is corrosive enough to strip off the copper oxide layer. It turns out, however, that the same process that makes the pennies shiny has bad consequences when it comes to copper pipes: it…
Read more
This science project presents an interesting puzzle. A disk of wood will float face-up; that is, with its circular cross-section parallel to the surface of the water. A long log of wood, however, floats on its side with the circular cross-section perpendicular to the surface of the water. If you think about it, disks and logs are both cylinders. Is there some intermediate length of cylinder that floats with the circular cross-section at a tilted angle? Try this experiment to find out!
Read more
Have you ever seen a "Hail Mary" football pass, where the quarterback tries to throw the ball as far as possible to reach the end zone and score a touchdown? Or a last second game tying soccer goal from midfield? How far the ball will go does not just depend on how hard a player throws or kicks it; it also depends on the angle at which the player launches the ball. In this sports science project, you will investigate how launch angle affects the distance that a ball travels by filming…
Read more
Do you like winter sports like sledding or skiing? Check out this winter-themed engineering project to build your own miniature "ski lift." Use it to transport small objects from one place to another, just like a real ski lift transports skiers from the bottom of a mountain to the top.
Read more
Imagine that you could make an important piece of laboratory equipment in your kitchen. With this science project idea, you can! You will create your own centrifuge out of a salad spinner and some putty. In science labs, centrifuges are used to separate different liquids and/or solids from each other. You can load your homemade centrifuge with samples and see how they separate. What
do you think happens to melted butter in a centrifuge?
Read more
Close your eyes for a moment and think about your favorite cake, pasta, and crusty bread. OK, you can open your eyes now, and please do not drool on your computer! What was the cake you pictured like? Was it light and fluffy? Did you imagine pasta with a silky, smooth texture? Was the bread you pictured wonderfully chewy? Did it give your jaws a workout? In this science fair project, you will explore an amazing substance in these foods, called gluten, and discover why these foods, all made from…
Read more
If you have ever prepared a cup of coffee or tea with sugar, you have probably seen that the grains of sugar quickly dissolve and completely disappear in hot water. But sugar is not the only type of solid that can readily dissolve in a liquid. In fact, there are some types of rocks that can be dissolved by common liquids. It might be hard to imagine large, hard rocks being eaten away by some ordinary fluids, right? But it actually happens all the time! In this geology science project, you will…
Read more
Imagine trying to put a solar panel on your roof or outside your home to generate clean, renewable energy. Where would you put it so it generates as much power as possible throughout the day? What direction should it face? Is there a way to take measurements to find the best location before you install the panel? In this project, you will use a tiny programmable device called a micro:bit to record light data and find the best place to put your panel.
Read more
You can measure the diameter of the Sun (and Moon) with a pinhole and a ruler! All you need to know is some simple geometry and the average distance between the Earth and Sun (or Moon). An easy way to make a pinhole is to cut a square hole (2-3 cm across) in the center of a piece of cardboard. Carefully tape a piece of aluminum foil flat over the hole. Use a sharp pin or needle to poke a tiny hole in the center of the foil. Use the pinhole to project an image of the Sun onto a wall or piece…
Read more
Did you know you can make paintings or drawings using sunlight? You can do it by leaving objects on top of special sun print paper until the light creates an imprint of the objects. How does this process work? How long should you leave the paper in the sun to get the best result? What does any of this have to do with the process of making the microchips that power our phones and computers? Try this project to find out! Check out this page for more science projects related to this process.
Read more
|
















